Cheap Tricks

I have a very easy-going husband who lets me put floral wallpaper on the risers of our front entry stairs. I love these stairs and I miss them very much. They were from our charming center hall colonial in New Jersey.

This staircase treatment is a super easy, super inexpensive way to make a statement on your steps. It's done with wallpaper and all told it took me about a day. This set of stairs was the focal point in a center hall colonial. If an entry hall seems to daunting, try it on your back staircase or basement steps. The good news is, that like wallpaper on walls, it can always be removed and repainted. If you've ever wallpapered a room, this project will be a breeze.

Start with a roll of wallpaper, wallpaper paste, wallpaper brush, wallpaper burnisher, scissors, a ruler, a straight edge, a damp rag and lots of razor blades. Many wallpapers come pre-pasted. Pre-pasted wallpaper doesn't always adhere well. So even if you purchase the pre-pasted kind, use paste anyway. You can use gloves if you prefer, but make sure they're the surgical kind that allow for finger mobility.

Measure the depth and length of the front of the stair riser. Cut pieces that are approximately 1" bigger around for however many steps you'll be covering. To begin, brush the wallpaper paste onto the front of the stair. Place the paper over the glue and smooth out with your hands. You'll have time for moving it around before the glue dries to get it right. (using a floral or other pattern works better than a geometric, which can be difficult to get straight). Once the paper is in its proper place, smooth it out with your hands and then take the wallpaper burnisher and smooth it out further in all directions. Make sure you don't skip this step. The burnisher is what really laminates the paper to the wooden stairs. You will have extra wallpaper glue oozing out a bit. That's normal.

Now you have to trim the excess paper. Take your straight edge and align it to the edges of the front of the stair. Holding the straight edge tight, make a cut across with a fresh razor blad to get a neat, close cut. Once you have trimmed all 4 sides, take your damp rag and wipe off the excess wallpaper paste. Wipe it off in the edges where it's oozed and the paper itself.

Remember to also: Rinse your rag regularly to avoid glue buildup. Change razor blades often. They get dull quickly and if it's not sharp, you'll end up ripping the paper instead of cutting it. You can usually patch mistakes. (Another reason to get a highly patterned wallpaper. Mistakes are less noticeable).

As was done here, you can also finish off the stair by painting stripes.